Big Core (Turbo Back) Exhaust Instructions

Removal

1. Remove Bed Liner, Rear Fascia Plastic and Stock Muffler Assembly.(See Figure #1)

2. Remove the Turbo Heat Shield.(See Figure #2)

3. Remove 02 sensor from Stock Downpipe.

[image:3[

4. Remove Factory Turbo Downpipe.(See Figure #3)

Installation

1. Install supplied Mounting Bracket with (4) M6X20 allen bolts. (See Figure #4)

6. Install supplied Turbo Down Pipe with Factory Hardware. (See Figure #5)

7. Reinstall Factory Turbo Heat Shield on New Downpipe using Factory hardware.(See Figure #6)

8. Install New Muffler assembly onto Downpipe and attach to Bracket using supplied (2) M10x1.5 Hex Bolts, (2) Fender washers, (2) Flat Washers and (2) M10x1.5 Nylock Nuts. (See Figure #7)

9. Reinstall factory 02 sensor. Reinstall Clipped Connector to back side of original bracket. (See Figure #8)

10. Tighten all Hardware and reinstall Bed Liner.

11. If not installing HMF Rear Bumper at this time reinstall Factory Rear Fascia using Factory T40 Torx hardware.