Polaris / Scrambler XP 1000 / Defender Front Bumper Installation Instructions

For Models: Scrambler XP 1000 (2014-2018)

Installation

1. Install the Skid Plate using the supplied (4) M8x25 ButtonHead Bolts, (8) 1/4" Washers and (4) M8 Speed Nuts. (For the Fairlead application, use the supplied hardware).

2. Use the (2) M8x35 Bolts and (2) 1/4" Washers to attach the upper tabs on the front bumper to the factory mounting location.

3. Use the (2) M8x55 Bolts, (4) 1/4" Washers and (2) M8 Nylocks through the lower portion of the frame, then through the lower mounting tabs on the front bumper.

4. Check alignment, center and tighten.(See Figure #1)

- Figure 1