Slip On Exhaust Instructions For Models: RZR XP® 900 (2011-2014)
1. Remove (4) Torx head bolts from the Center Rear Plastic. (See Figure #1)
2. Using a long piece of wire, remove the (4) springs holding the Silencer to the Frame, and the Silencer to the Head Pipe. (See Figure #2)
3. Pull back on the Silencer and remove the Gasket from the Head Pipe, being careful not to damage gasket.
Note: You will reuse this gasket with your HMF Silencer.
4. Slide the Silencer to the right to remove it from the vehicle.
1. Inspect the original gasket for wear. Replace if necessary.
2. Using the supplied hardware, install the (2) Hanger Brackets to the Front of the Frame using the existing holes. (See Figure #3)
3. Position your HMF silencer in place of the original. Use the supplied hardware to bolt the Silencer to the Previously-Installed Mounting Brackets. DO NOT TIGHTEN. Be sure to use the original or replacement gasket between the Silencer and Head Pipe.
4. Install the (2) Long Neck Springs (supplied) at the Silencer-to-Head-Pipe-Joint. (See Figure #4)
5. Install the Single Short Spring (supplied) at the lower left side of the Silencer. (See Figure #5)
6. Center the Silencer and Brackets. Be sure the lower bracket is seated over the bump in the frame. Tighten all the hardware and replace the (4) torx head bolts at the rear plastic.
7. Inspect all the areas around the exhaust to ensure proper alignment and clearances. (See Figure #6)
Note: HMF will not be held responsible for damage caused by incorrect installation.
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks:
