Slip On Exhaust Instructions

For Models: Spyder F3 S (2015-2017)

Removal

1. Loosen the clamp between the Primary muffler and secondary muffler. (See Figure #1)

Slip On Exhaust Instructions - Figure 1

2. Pull back on the secondary muffler to remove it from the hanger assembly.

3. Use a long piece of electrical wire to remove the 3 springs from the Head Pipe-to-Primary-Muffler Joint. (See Figure #2)

Slip On Exhaust Instructions - Figure 2

4. There is a rubber hanger above the Primary muffler that is difficult to reach. From the right (muffler) side of the machine, use a long screw driver or similar tool to push the rubber hanger toward the left side of the machine to slide it off of the muffler mount.

5. Slide the primary muffler toward the back of the machine to remove it. (See Figure #3)

Slip On Exhaust Instructions - Figure 3

Installation

1. Inspect the original donut gasket for wear or damage and replace if necessary.

2. With the silencer bracket bolts finger tight, carefully slide your new HMF slip on exhaust into the 3 original rubber grommets. (Light penetrating oil can be used to aid installation)

3. Using a long piece of electrical wire, install the 3 original springs at the head pipe to inlet joint.

4. Tighten the silencer bracket bolts along with any other hardware that you may have loosened during installation.

Discussion

Tuning

Typically, fuel tuning is not required when installing an HMF Exhaust on this machine. However, other modifications to the machine may require the need for fuel tuning to ensure the machine runs properly, and there is no damage to the exhaust system. See the tuning settings below for possible tuning solutions or Contact Us for more information.