- OR -

Exhaust Systems Can-Am® Outlander 1000

Print Instructions

HMF Racing Slip On Exhaust Instructions

For Models: Outlander 1000 (2012-2023)

Removal

1. Loosen the Stock T-Bolt Clamp and remove the Silencer Mounting Bolts and Silencer.(See Figure #1)

Slip On Exhaust Instructions - Figure 1

2. Remove the (3) Bolts and Plastic Bolt located in the trunk. (See Figure #2)

Slip On Exhaust Instructions - Figure 2

3. MODELS WITH REAR BUMPER Remove the Left Lower Bumper Mounting Bracket 

Installation

1. Install the supplied bracket using the (3) supplied M6 bolts, washers and original nyloc nuts.  (Top right bolt will not use a nyloc nut.  It will thread into the OE nut-sert clip.)  Use the supplied M8 bolt, washers and nyloc nut on front bracket hole.(See Figure #3)

Slip On Exhaust Instructions - Figure 3

2. Slide the supplied T-bolt clamp over the Silencer Inlet. 

3. Use the supplied hardware to mount the Silencer to the previously installed bracket.  Do not tighten.

4. Ensure proper exhaust alignment and clearance.

5. Install the supplied  Heat Shield where necessary.

6. Reinspect all areas around the exhaust system for proper alignment and clearance. 

Discussion

Hook me up! Get 10% off your next exhaust or equipment order.

Sign up for the HMF Community and receive the following perks:

  • 10% off your next exhaust or equipment purchase
  • Details about upcoming HMF products
  • Exclusive product giveaways

Tell us your vehicle for 10% off!

Sign Me Up!

No, thanks. I'll pay full price for my powersports needs.