Dual Slip On Exhaust Instructions

Removal

1) Use a Spring Puller or a Piece of Electrical Wire to remove the (4) Head Pipe-to-Silencer Springs and remove the Silencer.   

2) Remove the Donut Gaskets and inspect for wear or damage.  Replace if necessary.

Installation

1) Install the supplied Silencer Bracket to the Silencers. using the supplied hardware.  Do not tighten (See Figure #1)

2) Install the original or replacement Donut Gaskets into the Silencer Inlets.

3) Slide the Silencers/Bracket Assembly into the Rubber Mounting Grommets while carefully lining up the Inlets with the Head Pipes.  

NOTE:  IT MAY BE NECESSARY TO LOOSEN HEAD PIPE NUTS TO ALLOW PROPER EXHAUST SYSTEM ALIGNMENT

4) Use a Spring puller or a Long Piece of Electrical Wire to install (4) Supplied Springs at the Head Pipe-to-Inlet Joints.

5) Tighten all the hardware.

STOP!  Inspect all the areas around the exhaust system for proper clearance and adjust if necessary.