***Before working on your machine make sure it is parked on a level surface with the transmission in park and/or the parking brake engaged. ***
1. Temporarily install the provided (2) 5/16"x18 Self Tapping Flanged Head Bolts into the lower bolt holes in the rear sub-frame. This will create the threads in the sub-frame and make final installation of the bumper easier.(See Figure #1)
2. Remove the self-tapping bolts installed in the previous step.
3. Loosely install the bumper starting with the two lower mounting points and the provided (2) 5/16"x18 Self Tapping Flanged Head Bolts , then the upper mounting points using the provided (2) M8-1.25x20 Flanged Head Hex Bolts, (2) M8x1.25x20 Hex Bolts, and (2) M8x1.25x20 Hex Bolts.
4. Check for proper alignment and clearance then tighten all hardware.(See Figure #2)
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks: