- OR -

Store Equipment Can-Am Maverick X3 Glove Box Panel, Can-Am® Maverick X3

Print Instructions

HMF Racing Glove Box Panel, Can-Am® Maverick X3 Instructions

Installation

Glove Box Panel, Can-Am® Maverick X3 Instructions - Figure 1

1. Remove side panels from the front of center console. (both sides)(See Figure #1)

Glove Box Panel, Can-Am® Maverick X3 Instructions - Figure 2

2. Flip over and locate the corner circles on the backside of the plastic panels.  (both sides)(See Figure #2)

Glove Box Panel, Can-Am® Maverick X3 Instructions - Figure 3

3. Drill 3/8" hole (both sides)(See Figure #3)

Glove Box Panel, Can-Am® Maverick X3 Instructions - Figure 4

4. Install factory side panel then slide the HMF IQ Equipment Glove Box side panel into place and install the rear push pin. (Both sides)(See Figure #4)

Glove Box Panel, Can-Am® Maverick X3 Instructions - Figure 5

5. Making sure the new panel is sitting in the correct location drill second 3/8" hole through the plastic and install punch pin. (Both sides)(See Figure #5)

Glove Box Panel, Can-Am® Maverick X3 Instructions - Figure 6

Discussion

Hook me up! Get 10% off your next exhaust or equipment order.

Sign up for the HMF Community and receive the following perks:

  • 10% off your next exhaust or equipment purchase
  • Details about upcoming HMF products
  • Exclusive product giveaways

Tell us your vehicle for 10% off!

Sign Me Up!

No, thanks. I'll pay full price for my powersports needs.