1. Install the bumper on the vehicle by sliding it into place through the stock cutouts in rear plastics.
2. Use the supplied (4) M8-1.25x20 Allen Bolts, (8) ¼" Flat Washers and (4) M8-1.25 Nylock Nuts to bolt the two upper brackets of the bumper to the holes in the frame of the vehicle. DO NOT TIGHTEN.(See Figure #1)
3. Install the (2) M8-1.25x20 Hex Bolts, (4) ¼" Flat Washers, and (2) M8-1.25 Nylock Nuts to the lower portion of the vehicle's frame. DO NOT TIGHTEN. (See Figure #2)
4. Center and level the bumper then tighten the upper four bolts then the lower two.(See Figure #3)
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks: