Rear Bumper, Can-Am Maverick R Instructions 1. Using proper jack and jack stands, support the rear of the vehicle with the rear tires off of the ground.(See Figure #1)
2. Remove the (4) Factory Radius Arm Bolts and set aside for reuse.
Note: It is reccomended to break the bolts loose by hand.(See Figure #2)
1. Using provieded (2) M10-1.5x25 Hexbolts, (4) 3/8" Flatwashers, (2) M10-1.5 Nylock nuts) insert the support arms of HMF Rear Bumper through the openings in the rear plastics, just above the exhuast opening, and hang the bumper on the frame brace.(See Figure #3)
(See Figure #4)
2. Reinstall the Factory Radius Arm Hardware through the HMF Rear Bumper and into the factory mounting points. (See Figure #5)
3. Set final alignment of the Rear Bumper and tighten all hardware.(See Figure #6)
