Tuesday, January 12th, 2010
Competition Series Insert Installation
In this video, we show you how to change out the inserts for the HMF Competition Series. This is a simple procedure that requires only an allen key.
Step 1: Remove the allen screws on the Euro End Cap
Step 2: Remove the current insert. (If you are going to keep the Spark Arrestor in, make sure the arched side is facing in towards the inlet.)
Step 3: Decide which insert you want to use, and place it on the exhaust, lining up all 4 holes.
Step 4: Place the Euro End Cap over the Insert, again, lining up all 4 holes.
Step 5: Start each screw, but do not completely tighten. Once you have all 4 screws started, tighten each one down and you're ready to ride.
Latest Resources
05/16 HMF Optimizer Instruction...
02/22 HMF Tech Video - Repack 1...
01/18 Mini Series
01/18 QRS Series
01/13 Swamp & Swamp XL Series
01/13 Penland Pro Series
01/13 Competition Series
01/13 Performance Series
05/03 Exhaust Repack Instructio...
05/03 Exhaust Repack Instructio...
Testimonials
“You can't beat the quality craftsmanship put into every HMF exhaust system. Just ask a man who owns one.”
- Mike Penland
GNCC Pro



Comments
(+) Add a comment
There are no comments for this resource.