hi-per wheels design

[becker_250x]

hey everyone though you all might enjoy these pics if your a fan of hi-per wheels which I am greatly. the picture is a 4+5 offset rear wheel with red beadlock, I drew this wheel in AutoDesk Inventor 8, in my 10th grade engineering class where we use this program everyday. I did this project as a fun project just to see how tough it might be, all the small details were a bit complicated but I completed it in 2 weeks. (also, ignore the small inner ring that looks to run through all of the support parts, it was a error in the computer due to file size.) (and also they r quite large pictures so please be patient with me.) http://i2.photobucket.com/albums/y21/iceman1489/d7865795.jpg http://i2.photobucket.com/albums/y21/iceman1489/a6b74394.jpg http://i2.photobucket.com/albums/y21/iceman1489/bc68359b.jpg

[becker_250x]

no feedback ?

[redrunner]

Nice work young man, I started out with a pencil and t-square in 10th grade..we actually had classes on shading in details to look curved.

[becker_250x]

ya it's amazing how far technology has come, we still start out every year with pencil and paper only to get a feel for it too.

[becker_250x]

another thing i shuld mention is that each part (bolts, carbon fiber halves, center piece and beadlocks) is a serperate part then was constrained together to make it look how it is there

[bike raper]

hans definity has a good looking thing going here, keep up the good work. Jason Micheal Jakubik