dobeck settings?

[grizzman465]

i just installed my pipe (love it!)and optimizer yesterday and i noticed all my settings are on 4.what should they be on?

[motoz/HMF]

Look here:
https://hmfengineering.com/forums/showthread.php?t=1942

[grizzman465]

thanks. when i turn the key on and dont start the bike i have a red and a green light flash (the improper installation code) but when i start the bike it does the 8 second green light stroll its installed right...right?

[motoz/HMF]

Gotta start it......

Then if you get the green cycling its ok

[grizzman465]

thanks. ok i just did a test run and it likes to die when you try to take off from a stop.any suggestions?

[motoz/HMF]

What machine do you have.....says grizzman but you are in the rincon forum area.

Rincon:
Rincon 680 4 5 4 5 4 HIGH ELEVATION or IDLE PROBLEMS ? try 2 5 4 5 4
AND
I have seen some rincon 680 owners complain about: High, No or erratic idle problems.

Reports from several forums are that the IACV (idle air control valve) sticks because of the grease in there, especially in cold temperatures.

I can't tell you on how to do this because I cannot verify the procedure AND the IACV has tamper proof torx screws holding the cover on.

BUT those tamperproof torx bits are out there.
The IACV is on the throttle boxy under a cover.
Use throttle body cleaner ONLY to clean out the excessive grease in the valve.


This should eliminate the idle problems in cold temps on the rincon.

[grizzman465]

i have a rincon 680. the temps arent cold around here i live in NC and i havent ever had any IACV problems through my almost 1500 miles (ive heard about that before)its in the lower 80's here and were at sea level:confused:

[grizzman465]

ok i tried 2 5 4... and it works great i can ride my wheelies now thanks for a great product!!! and for great cust. service

[motoz/HMF]

Nooooooooo problemo.
Glad you got it all sorted out.