For Models: Outlaw 500 (2006-2007)
1. Remove the Spring at the top rear of the Silencer.
2. Loosen the Clamp at the Silencer-to-Head Pipe Joint.
3. Pull and rotate the Silencer counter-clockwise in a corkscrew motion.(See Figure #1)
4. Be sure the original gasket is still in place and free from wear or damage. Replace if necessary.
1. Slide the Clamp onto the Inlet of the Silencer.
2. Push and rotate the HMF Silencer clockwise in a corkscrew motion, then make the connection at the Silencer-to-Inlet Joint.
3. Align and center the Silencer and tighten all hardware.
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks: